Is a Dodge 360 a good motor?

The Mopar 360 can make an excellent performance engine. It was introduced with a 2-bbl carburetor in 1971. Not intended as a performance engine, it also featured a cast crankshaft and low compression ratio (8.5 to 1) cast pistons. … In spite of this rocky start, the 360 can be built into an excellent street engine.

Will a 318 intake fit a 360?

The 360 heads and Intake swap will fit on the 318, but the compression will be around 7.2:1, which is not very good for performance, which is not to say that the heads cannot be shaved .

How much HP does a 318 have?

The 318 four-barrel, used on police pursuit and other cars, produed 165 hp and 240 lb-ft of torque.

What engine is better 318 or 360?

The advantage of the 360 over the 318 for a street/strip engine is the obvious cubic inch advantage, the longer stroke crank has more leverage for more torque, and the larger bore size lets you use cylinder heads with larger valves for more airflow.

How do you tell if you have a 318 or 360?

All Magnum engines are stamped either 360 or 318 on the driver’s side near the rear of the block. The casting number found on all 360 Magnum blocks is 5302006, whereas the 5.2/318 Magnums are 53006714 or 53006657. Otherwise, the 5.2 and 5.9 appear pretty much identical.

How many miles will a 318 last?

Like any engine, it depends on routine maintenance and how the engine has been treated over its lifespan. Some may last 2 miles, some 400,000 or more.

Is the Dodge 318 a good engine?

The Good And The BadIn terms of durability, the Mopar 318 is robust. The bottom end of most 318 engines used a cast-iron crankshaft, and though these are not as desirable as a forged crank, the cast-iron piece has proven to be very reliable.

What vehicles have the 46RE transmission?

A518 (46RH/46RE)

  • Dodge Ram pickup and vans 150/250/350 V8 and diesel engines (DGT)
  • Dodge Ramcharger SUV 1988-1993 5.2L & 5.9L V8.
  • Jeep Grand Cherokee 1993 5.2L, 1998 5.9L.
  • 1996 Dodge Dakota V8 (Also 98-03 Dakota 5.9L R/T)
  • 1998-2003 Dodge Durango 5.9L V8 (4WD or 2WD)
  • 1998–2003 Dodge Dakota R/T.

How much does it cost to rebuild a 360 engine?

Re: How Much Does it cost to rebuild 360 motor A rebuild at a reputable shop can set you back about 700- 800 bucks average depending on what you can do yourself, the condition of your block, heads, and rotating assembly etc.

Posted in 1

Leave a Reply

Your email address will not be published. Required fields are marked *